Finger Drive with Rectangular Finger

commonly sought after sprocket system
available in any tooth configuration.
Utilizes rectangular fingers for increased stiffness and load capacity.
fingers provide internal support for the conveyor around the sprocket
fingers can be located at every second tooth or every tooth or any other spacing requirement.
sprockets are commonly split to allow easy attachment to drive shaft
bosses attached to the outside of the sprocket
bosses can be permanently attached via weld or temporarily via bolting (consult with HBS for advice).
bore to center of sprocket is based on equipment in use, i.e. 1″, 1.5″ etc.
Drive does not have geared teeth.
Available as flange or non-flange drive with flange typical in outer web use and non-flange for inner web support.